Machine sewing

Sit down at the machine

Meet your sewing machine and stitch your first real projects. Start anywhere; every lesson stands on its own.

on the bench

01 · 6 lessons

Meet Your Machine

Thread it, wind a bobbin, balance the tension and sew your first straight seams on the Janome Juno J30.

Meet your Janome Juno J30

This lesson orients you to the Janome Juno J30 before you sew a stitch: you will locate every control you touch during a seam, and run the machine once without thread to feel its speed and watch the needle and feed dogs move.

9 steps · EN · УК

Nº 02

Wind and load a bobbin

Wind thread evenly onto a bobbin and load it into the Janome J30's top-loading hook so the lower thread feeds without loops or tangles. A bobbin wound unevenly or seated backward is one of the most common causes of messy stitches, so get this step right before you sew a seam.

9 steps · EN · УК

Nº 03

Set Up a Sewing Machine: Threading, Tension, and Stitch Length

Before you sew a single garment seam, set the machine up so its stitches hold: match thread to needle, thread the machine through the take-up, set the stitch length for your fabric, and balance the tension by testing on a scrap. These few checks are the difference between a seam that lasts and one that puckers, tangles, or pulls apart.

8 steps · EN

Nº 04

Stitch and finish a plain machine seam so it lies flat and won't fray

Join two pieces of cloth with a plain machine seam, overcast the raw edges together so they do not fray, and press the seam so it lies flat. A seam prepared, finished, and pressed this way keeps its shape and does not ravel at the edge.

6 steps · EN

Nº 05

Sew an even seam and turn a crisp corner

Practice keeping a steady 1.5 cm (5/8 in) seam allowance by tracking the needle-plate guide lines instead of the needle, then pivot a clean 90-degree corner. This is the seam-guiding skill every project after this one depends on.

9 steps · EN · УК

Nº 06

Zigzag a raw edge so it won't fray

Learn to overcast a raw fabric edge with the zigzag stitch so it stops fraying in the wash. This is the beginner alternative to an overlocker and finishes seam allowances on almost any woven fabric.

9 steps · EN · УК

02 · 4 lessons

Your First Machine Projects

Put the machine to work: hems, a drawstring bag, a buttonhole and a quick mend.

Nº 01

Hem trousers with a double-fold hem

Shorten a pair of trousers to the correct length with a double-fold hem sewn on the machine. Both folds enclose the raw edge, so there's no fraying and no extra finishing step.

10 steps · EN · УК

Nº 02

Sew a simple drawstring bag

Sew a simple drawstring bag from a single rectangle of fabric — straight seams, a folded casing, and a threaded cord. It's a good first real project once you can sew a straight line and finish a raw edge.

10 steps · EN · УК

Nº 03

Sew a one-step buttonhole on the J30

A one-step buttonhole uses the J30's button carrier to size and stitch a buttonhole to the exact button you're using, then you cut it open by hand. It's the step that turns a plain placket into a working shirt or cuff closure.

10 steps · EN · УК

Nº 04

Machine-mend a burst seam or a small hole

Two quick machine repairs in one lesson: restitch a seam that has popped open, and patch a small hole or tear from behind. It's the same mending value as hand repairs, done faster with the machine.

10 steps · EN · УК